AMX Novara SP-08-E-US, Инструкция по эксплуатации

Страница: 34 / 37

Programming Ethernet Keypads
27 Instruction Manual - Novara Ethernet Keypads
Terminal Commands (Cont.)
Command Description
SET IP Sets the IP configuration of a specified device.
Enter a host name, type ( DHCP or Fixed ), IP address, subnet mask, and gateway IP
address.
Note : “DHCP” implies “DHCP with link-local fallback".
Note : For NetLinx Masters, the "Host Name" can only consist of alphanumeric
characters.
• Enter Y (yes) to approve/store the information into the Master.
• Enter N (no) to cancel the operation.
Note : This command requires a reboot to enable new settings.
Example:
>SET IP
--- Enter New Values or just hit Enter
to keep current settings ---
Enter Host Name: MLK_INSTRUCTOR
Enter IP type. Type D for DHCP or S for Static IP and
then Enter: DHCP
Enter Gateway IP: 192.168.21.2
You have entered: Host Name MLK_INSTRUCTOR
Type DHCP
Gateway IP 192.168.21.2
Is this correct? Type Y or N and Enter -> y
Settings written. Device must be rebooted to enable
new settings.
Note : Metreau keypads can also be set to Static IP or DHCP Mode by using the ID
Pushbutton. See the Toggling Between IP Addressing Modes: DHCP and Static
IP
section on page 10 for details.
SET LOCATION Sets the location parameter for NDP.
Syntax:
SET LOCATION <location>
• Maximum length = 25 characters. If the name entered exceeds 25 characters, it
will be truncated.
Note : This command requires a reboot to enable new settings.
SET TELNET PORT Sets the device’s IP port listened to for Telnet connections.
Example:
>SET TELNET PORT
Current telnet port number = 23
Enter new telnet port number (Usually 23)(0=disable Telnet):
Once you enter a value and press <Enter>, you get the following message:
Setting telnet port number to 23
New telnet port number set, reboot the device for the change to take
effect.
Note : This command requires a reboot to enable new settings.
See the Enabling/Disabling Telnet on the Keypad section on page 28 for additional
information.
SET TELNET USERNAME Set the user name for a secure Telnet session.
• Default = blank (no user name required)
• See the Setting a Telnet User Name and Password section on page 22 for details.
SET TELNET PASSWORD Set the Password for a secure Telnet session.
• Default = blank (no password required)
• See the Setting a Telnet User Name and Password section on page 22 for details.
SHOW CONNECTION LOG Show the master connection log for the device