AMX Novara SP-08-E-US, Инструкция по эксплуатации, Страница: 17 / 37

Configuring Novara Ethernet Keypads
10 Instruction Manual - Novara Ethernet Keypads
Toggling Between IP Addressing Modes: DHCP and Static IP
Novara Ethernet Keypads support both DHCP and static IP addresses. You can use a static IP address which you can set
via a Telnet command (SET IP), or you can use the factory default static IP address (192.168.1.2).
With the keypad powered and booted up (or in ID Mode), you can toggle between the DHCP and Static IP modes by
pressing and holding buttons 1 and 2. The LEDs on buttons 1 and 2 blink while you keep them pressed. Hold them until
the LEDs begin blinking at double the rate (approximately10 seconds), then release the buttons.
When you release the buttons, the keypad toggles either from static to dynamic (DHCP) IP addressing or vice versa and
remains in that mode until you use the buttons to toggle the IP mode again or you perform a factory reset. The keypad
automatically reboots to complete the process.
Note: You must wait until the keypad is finished booting before toggling the IP address. Pressing the buttons while
booting will cause the keypad to restore its factory default settings.
Assigning a Device ID to a Keypad
When used in conjunction with the ID Mode feature in NetLinx Studio, you can momentarily press buttons 1 and 2 on
the keypad to assign a device address to the keypad. See the NetLinx Studio Instruction Manual or consult the online
help tool in NetLinx Studio for more information.
Resetting the Keypad
To perform a factory reset of the Keypad, press and hold buttons 1 and 2 for 10 seconds during the boot process . The
LEDs on buttons 1 and 2 blink while you keep them pressed. Hold them until the LEDs begin blinking at double the rate
(approximately10 seconds.) Release the buttons and the keypad will reset. During factory reset, the backlight turns off
for all buttons, but all buttons should be back online after 1-2 minutes. If you do not hold in the reset button until the
LEDs begin blinking faster, the reset does not occur. (There is no soft reboot with the Reset button, but you can perform
a soft reboot from the web pages.)
Note: When you reset a keypad, the keypad is restored to the factory default, so you will lose all configuration data as the
defaults are restored.
Restoring the Factory Image on the Keypad
To restore the factory image on the keypad, press and hold buttons 1 and 2 for approximately 20 seconds during the
boot process. The LEDs on buttons 1 and 2 blink while you keep them pressed. Hold them until the LEDs begin
blinking at double the rate (approximately 20 seconds.) While pressing the buttons, disconnect and reconnect the cable
from the LAN port on the rear panel of the device to restore the factory image firmware on the keypad.