AMX Modero Viewpoint MVP-5200i, Руководство по эксплуатации/справочник

Страница: 168 / 202

Programming
160 MVP-5200i Modero Viewpoint Widescreen Touch Panel
Intercom Commands (Cont.)
^ICM-TALK
^ICM-LISTEN
Intercom modify
command.
Intercom modify command. For backwards compatibility both versions are supported.
In this release, however, the TALK and LISTEN subcommands are ignored. The
microphone and/or speaker are activated based on the initial mode value of the intercom
start command and the audio data packet flow is started upon receipt of this command by
the panel.
Syntax:
SEND_COMMAND <DEV>,"'^ICM-TALK'"
Variables:
None.
Example:
SEND_COMMAND TP1,"'^ICM-TALK'"
^ICM-MICLEVEL
Intercom modify
command.
Used to set the microphone level during an intercom call.
Syntax:
SEND_COMMAND <DEV>, "^ICM-MICLEVEL"
Variables:
Valid levels are from 0 to 100.
Example:
SEND_COMMAND TP1, "^ICM-MICLEVEL,40"
^ICM-MUTEMIC
Intercom modify
command.
Set the state of the microphone on a panel to muted (1) or unmuted (0). At the start of
each call the microphone starts out unmuted.
Syntax:
SEND_COMMAND <DEV>, "^ICM-MUTEMIC"
Variables:
None.
Example:
SEND_COMMAND TP1, "^ICM-MUTEMIC,1"
^ICM-
SPEAKERLEVEL
Intercom modify
command.
Used to set the speaker level during an intercom call.
Syntax:
SEND_COMMAND <DEV>, "^ICM-SPEAKERLEVEL,55"
Variables:
Valid levels are from 0 to 100.
Example:
SEND_COMMAND TP1, "^ICM-SPEAKERLEVEL,55"