Programming The Mio R-3
15
Mio Modero R-3 Remote - Instruction Manual
Serial Commands (Cont.)
^SHO
Show or hide text with a set variable text range
Syntax:
"'^SHO-<variable text address range>,<command value>'"
Variables:
• variable text address range = 1 - 6; the address range corresponds to the dynamic line number.
• command value = (0= hide, 1= show).
Example:
SEND_COMMAND Panel,"'^SHO-1,0'"
Hides text on dynamic line 1 of the LCD button.
SLEEP-#
Set the Sleep timer or put the remote to sleep immediately. This command can be used if a sleep time other than 3, 6, 9,
or 12 seconds is desired.
Syntax:
"'SLEEP-#'" (timed sleep; a persistent command)
Variables:
• # = 0 - 60 in seconds; time to wait before going to sleep. Default is 30. 0 sets the device to never sleep.
Example:
SEND_COMMAND Panel,"'SLEEP-45'"
Sets the sleep timer to 45 seconds. After 45 seconds of inactivity, the remote will go to sleep.
SEND_COMMAND panel,"'SLEEP'"
Force the keypad to go to sleep.
@SSL
Sends a string to the master upon going to sleep
Syntax:
"'@SSL-<new text>'"
Variables:
• new text = 1 - 20 ASCII characters. Default string is SLEEP.
Example:
SEND_COMMAND Panel,"'@SSL-KeyPad Sleep'"
Sends the string " KeyPad Sleep'" to the master at time of sleep.
@SST
Sends a string to the master upon startup
Syntax:
"'@SST-<new text>'"
Variables:
• new text = 1 - 20 ASCII characters. Default string is STARTUP.
Example:
SEND_COMMANDPanel,"'@SST-Panel Start'"
Sends the string " Panel Start " to the master at time of start up.
@SWK
Sends a string to the master upon wake up
Syntax:
"'@SWK-<new text>'"
Variables:
• new text = 1 - 20 ASCII characters. Default string is WAKEUP.
Example:
SEND_COMMAND Panel,"'@SWK-Wake KeyPad"
Sends the string " Wake KeyPad " to the master at time of wake up.
^TXT
Sets non-unicode text. Assign a text string to those buttons with a defined address range.
Syntax:
SEND_COMMAND <DEV>,"'^TXT-<vt addr range>,<new text>'"
Variables:
• variable text address range = 1.
• button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons 1 = Off state and
2 = On state).
• new text = 1 - 50 ASCII characters.
Example:
SEND_COMMAND Keypad,"'^TXT-1,Test Only'"
Sends text to variable text line on display.
Note: You must send an ^FML command before sending variable text to an R3 remote.
