Setup Mode
9
Mio Modero R-3 Remote - Instruction Manual
Setup Mode
Overview
The
Setup
mode allows you to set the following device features on the Mio R-3:
Transmit Mode
Timeout Adjustment
Download Mode
Debug Mode
Firmware Version
Device ID
LED Awake Brightness
LED Sleep Brightness
ZigBee Pan ID, Channel, and System Connection
Network Scan
To enter
Setup
mode:
1.
Press and hold the
STOP
button and the
INPUT
button. The two buttons must be pressed within 0.1 seconds of each other
and held down for 2 seconds. The device indicates you are now in
Setup
mode. The available modes are listed below.
2.
Press the
EXIT
key when you are finished. The Mio R-3 will automatically exit
Setup
mode after 30 seconds unless the device is
in
Download
mode.
NOTE:
Your settings will not be lost in the event of battery removal or failure.
Transmit Mode
Press button
1
to select from one of the different available transmission modes. The
Transmit
mode changes each time
1
is pressed.
The predetermined modes are:
IR 38 Khz
IR 455 Khz
ZigBee Mode
IR 38 + ZigBee
IR 455 + ZigBee
The display indicates the selected mode. 30 seconds after selecting the mode, the menu returns to
Setup
mode.
Timeout Adjustment
Press button
2
on the remote to change the sleep timeout from the default. Each time
2
is pressed, the sleep timeout raises
incrementally. The predetermined sleep timeouts are 3,6,9, and 12 seconds.
The display indicates the selected sleep timeout. 30 seconds after selecting the mode, the menu returns to
Setup
mode.
Download Mode
In order to download new firmware or a new configuration or font file to the Mio R-3 remote using the remote's program port (see
Using the Programming Jack on The Mio R-3
section on page 11 for details), the remote must first be placed into
Download
mode.
Press
3
on the remote to toggle the
Download
mode
OFF
and
ON
. The
Download
mode must be ON before you can download a file to
the Mio R-3 device. While the
Download
mode is
ON
, the device will not go to sleep. Once the download is complete, this setting
must be returned to
Download Off
. A firmware download will cause the remote to reset and this will automatically reset the remote
to
Download Off
.
To leave
Download
mode, press the
EXIT
button.
Debug Mode
Pressing button
4
on the remote toggles
Debug
mode between
ON
and
OFF
.
The remote has a feature known as
Debug
mode. When the remote is in
Debug
mode, pressing any of the remote's buttons will
cause the remote to display the corresponding channel code (used for programming the control system) on the remote. The
channel code will be shown on the remote as long as the button is pressed. The remote indicates that it is in
Debug
mode by
displaying the word
DEBUG
between button presses.
Pressing the
4
button toggles to the new mode. 30 seconds after selecting the mode, the menu returns to
Setup
mode.
Roaming Diagnostic Mode
When in
Debug
mode, press button
4
again to enter the
Roaming Diagnostic
mode. The display will read "ROAM DIAG ON". Press
Exit
to display the parent PAN ID, displayed as "P. XXXX", and the latency of the signal, displayed as "L.XXXX". A bar below the main
display shows the current signal strength, and allows tracking of signal strength throughout a PAN.
To get out of
Roaming Diagnostic
mode, press
Exit
again to return to the
Setup
menu, and then press button
4
.
