Touch Panel Interface - Control Pages
7
Design XPress User Interface Guide
Multiple Select
: Press to allow multiple selection of multiple Audio Zones.
Select All
: Press to select all Audio Zones.
Source Select
: Press to open the Source Select page where you can select a different
audio source for the selected zone.
Each audio zone in the system has default preset values that are used when the zone is turned on.
When a zone is turned on, it returns to either the last known volume level, or the preset level -
whichever is lower
- to avoid excessive volume (that might be jarring or even cause damage to
equipment).
To modify these default settings for a zone you must press and hold an audio zone button on the
Music page (FIG. 7) for two seconds to gain access to the audio settings screen for that zone.
Touch Panel Interface - Audio Zone Settings Page
The Audio Zone Settings page (FIG. 8) allows you to modify the volume, bass, treble, balance, and
loudness settings that will be used when the zone is turned on.
Use the arrow buttons to adjust the settings.
Single press the arrow buttons to incrementally adjust the level.
Hold the button down to ramp the level.
FIG. 8
Touch Panel Interface - Audio Zone Settings Page
These settings go into effect only when a zone transitions from off to a valid audio
source. These settings are not activated when the zone transitions from one audio
source to another.
