AMVAC SmartBox, Руководство по эксплуатации и каталог запасных частей

Страница: 72 / 81

71
D
C. Installation of new meter and / or meter gasket:
1. Install the meter assembly as stated below and in the SmartBox
®
Operator’s Manual
under “Installation: Meter to Base Container”.
a. Position the meter with the 45° meter discharge opening facing forward
(pointing toward the short side of the base container and pointing toward the
planter tool bar).
b. Ensure the gasket (always use a new meter gasket) and meter screen are
properly installed on the meter.
c. Place the ¼” x 1” bolts up through the meter, base container flange, and ¼”
flat washer as show in figure 2 above. Lightly secure with the lock nuts.
d. Examine meter gasket to make sure it is centered to provide a good seal.
e. Tighten all bolts securely. Torque bolts to 25-30 in-lbs. Do not over-tighten
or under-tighten bolts. NOTE: A 60% to 75% compression ratio is
required for the gasket to properly seal.
f. Apply a thin layer of silicon to the outside of the gasket after it has been
installed on the base container.
2. Place the base container back on the cradle and replace the eight bolts holding it
into position as stated in the SmartBox
®
Operator’s Manual under: “Installation: Base
Container to Cradle”.
3. Replace the transfer container.
4. Turn on controller. Follow directions on controller screen to configure meter.
5. Plug meter into wiring harness. Configure and calibrate if a new meter has been
installed. Used meters returned to their original rows do not require reconfiguration
or re-calibration.