AMT IPT 2P5X Series, Спецификация, информация и руководство по ремонту запасных частей

Страница: 4 / 12

Specifications Information and Repair Parts Manual
IPT 2P5X, 2S5X, 2S5XC, 3S5X Series
2S5X-250-00 4 2/2018
Periodic Maintenance
1. Clean outside of pump and engine to remove accumulated dirt, oil and
grime.
2. Maintain engine according to engine manufacturer’s recommendations.
3. It is recommended that a replacement shaft seal and seal kit be kept on
hand at all times.
4. Check for leaks during pump operation. Leaks may occur at shaft seal,
casing to bracket connection, suction and discharge manifold connections,
and through pump casing and bracket. Investigate and repair any leaks
immediately.
NOTE: Engine failure due to water intrusion into crankcase caused by a leaking
seal will not be covered by engine or pump warranty.
5. Mechanical shaft seals are a wear item and require periodic replacement.
Seal life is dependent on many factors including liquid pumped, sediment
type, operating point, and suction conditions.
6. Inspect for loose fasteners. Tighten any loose fasteners immediately.
BEARING HOUSING REPLACEMENT FOR PEDESTAL
MODELS
1. Remove the front pump assembly as described under Shaft Seal
Replacement.
2. Disassemble the pedestal drive kit (Ref. No. 37) from pump adapter by
removing the four screws and O-rings.
3. Remove pedestal drive kit (Ref. No. 37) and replace entire unit as
recommended by factory to insure proper operation.
4. Reverse steps 1 thru 3 to reassemble pump.
IMPORTANT: After pump is assembled, it is necessary to rotate pump shaft
by hand to check for striking of the impeller. If striking or rubbing occurs, adjust
impeller shims as required (See Shim Adjustment).
IPT Series 2P5X, 2S5X, 2S5XC & 3S5X Pumps