i
Table of Contents
Uncrating/Installation Instructions
122993-618
A WORD FROM STERIS CORPORATION
Follow each step of the uncrating/installation instructions
in the
order presented
. Open the carton carefully to avoid damage
to the equipment inside. If you find any indication of damage to the
equipment (no matter how slight), show it to your supervisor.
To properly install this unit, you will need the Equipment Drawings
(previously furnished), showing all utility service and space re-
quirements. If drawings cannot be located, replacement copies
may be obtained by writing, wiring, faxing or telephoning STERIS
giving the serial, equipment and model numbers of your washer.
Once installed, washer operation should be tested by a STERIS-
trained service technician prior to your usage of the equipment.
If STERIS supervision is desired for installing and starting up this
equipment, contact the STERIS Regional Office nearest you.
The Reliance
®
300 Laboratory Glassware Washer is designed for
efficient cleaning of laboratory glassware, plasticware and metal
goods typically used in research, support production and quality
control laboratories. This washer is specifically designed to only
process goods as outlined in the Operator Manual (P-122993-619).
If there is any doubt about a specific material or product, contact the
manufacturer of the product for the recommended washing
technique.
A summary of the safety precautions to be observed when uncrating,
installing and testing this washer can be found in Section 1 of these
instructions. Do not begin uncrating/installing this equipment until
you have become familiar with this information.
IMPORTANT:
Be sure to check the Occupational Health and
Safety Act, as well as local electric and plumbing codes, for any
special requirements that may pertain to installation of this unit.
©1998, STERIS Corporation. All rights reserved.
Indications for Use
Advisory
