Amplicomms Watch & Care V130, Руководство пользователя

Страница: 45 / 59

Helpline UK 0844 800 6503
(See page 44 for costs and hours of operation)
beep. Move the receiver nearer to the transmitter. If necessary, opti-
mum range can be achieved if both the Baby unit and Parent unit
antennas are extended vertically.
Registration
In delivery state the transmitter is pre−registered at the receiver
(Watch&Care V132: both transmitters). If necessary or if a another camera is
added to the system, registration can also be completed manually:
1 Switch the transmitter off (switch set to OFF ). Remove the batteries of
the receiver for a few seconds if necessary.
2 Switch the receiver on.
3 Press and hold down the button until [C1] appears in the display.
4 Use the buttons to select the desired camera [C1] ... [C4] .
5 Press the button briefly. The Link LED flickers for approx. 10
seconds. During this time, you must perform steps 6 and 7.
6 Switch the transmitter on (switch set to ON ).
7 Press the registration key on the back side of the transmit-
ter. After a short time the video from the transmitter will
appear on the screen if the registration was successful. If
the registration failed, “Out of Range“ appears on the
screen.
O
PERATING THE
R
ECEIVER
38