TSCAN-750 User Manual | 3
TSCAN-750 Temperature Scanning Entry System supports three usage modes and is equipped with different
platform software for more powerful functions.
1. Company Mode - Combined facial recognition and temperature measurement for employee access control and
attendance management. Equipped with web interface to view historical statistics.
2. Education Mode - Combined facial recognition and temperature measurement for student/staff access control and
attendance management. Equipped with web interface to view historical statistics.
3. Quick Screening Mode – Allows entry based on temperature reading without facial recognition. Temperature and
entry statistics available via mobile app.
Notice:
• To ensure the normal operation of the temperature measurement module, the device needs to be warmed up for
more than 2 hours after it is powered on.
• During installation and use, all electrical safety regulations of the country and region of use must be strictly
observed.
• When wiring, installing, and disassembling, please be sure to disconnect the power supply. Do not perform any of
these operations with electricity.
• If the device emits smoke, produces unusual odors, or makes noises, immediately turn off the power and unplug
it; contact the dealer or service center.
• If the equipment is not working properly, please contact customer service. Do not disassemble or modify the
equipment in any way. (The company does not assume any responsibility for problems caused by unauthorized
modification or maintenance.)
• Do not drop objects on the device or vibrate the device vigorously. Keep the device away from magnetic
interference.
• Avoid installing the device where the surface vibrates or is vulnerable to shock.
•
Avoid installing the device at the air outlet of the air conditioner or in a place with large airflow fluctuations.
• Avoid placing the device in direct sunlight, poorly ventilated locations, or near heat sources.
• Ensure that the equipment is installed vertically.
• Do not use the device in high temperature, low temperature or high humidity environments.
• Biometric products cannot be 100% suitable for any anti-counterfeiting environment. High security level places,
please use combination authentication.
•
Do not touch the temperature probe with your fingers or blow air on the probe.
• Please make sure no hair, sweat, or hat covers your forehead while measuring temperature.
• If the forehead is cold, allow enough time for the forehead to reach room temperature before taking temperature
measurement. Examples: After washing the face, applying ice, or entering the room from outside in winter
conditions.
• Do not aim the lens of the device at strong light objects, such as the sun, incandescent lamps, etc.; otherwise, it
will cause lens damage.
Introduction
Downloaded from
Downloaded from
Downloaded from