IPX5151 | ETHERNET PAGING CLIENT
PAGE 5
Device Setup Via Browser
System
Unit Configuration:
We can enter a meaningful Device Name here, e.g. “Room
A Paging Client”. The name will be shown in Device Info page of iPX5151 and iPX5101
Paging Server - Client Browser tab.
Authentication:
You can alter the user name and password to avoid unnecessary
access to the system.
Update Firmware:
Firmware is stored in the unit’s memory. Should there be any
updates available, use this section to perform system upgrades accordingly. Refer
page 6 on firmware updating.
Backup & Restore:
You can backup the configuration and can reset the settings
to default settings.
Device Name
Room A Paging Client
Enter new username
Enter new password
Paging Configuration
Paging Enabled:
Enable this setting all the time.
Auto Connect:
We can either turn On the Auto Connect to allow iPX5151 search
and connect to Paging Server automatically or turn Off the setting and specify the
Paging Server IP address here.
Note:
If paging Server IP address is changed to an unknown value, turn On the
Auto Connect allow iPX5151 auto capture the server IP address and show up in the
device information page.
Remote Trigger
Enabled:
If PM1000 or TI6100 were used as the paging audio source, enable this
setting such that iPX5151 Remote Trigger port accept the devices triggering via dry
contact.
No Priority:
There are 13 priority levels. No priority is the 13th level which is the
lowest. Disable this setting allow us to set a higher level for paging device that
connected to this iPX5151. The lower the priority number, the higher the priority
level.
Auto Override Low Priority (AOLP):
Enable this setting if we want to allow
device that connect to this iPX5151 Remote Trigger port to override other lower
priority devices. More about AOLP can refer to iPX5101 instruction manual.
Paging Enabled
Auto Connect
192.168.0.101
Enabled
No Priority
Auto Override Low Priority
Paging Server IP Address
Priority
