PAGE 6
iEP1200 | ETHERNET EMERGENCY PAGING MICROPHONE PANEL
Connecting The Unit - Full IP Based with iEP1200
iPA5060
ETHERNE
T REMOTE
AMPLIFIER
TERMINAL
amperes
MIC IN ETHERNE
T SPEAKER OUT
AC INPUT
AC POWER
BATTERY
NETWORK
STREAMING
Network Switch
iPA5060
MR1301
iEP1200
Switch or sensor for
message activation
Gnd
Bal.audio out
2C cable
DC 24V
+
Cat5e
iPA5060
ETHERNE
T REMOTE
AMPLIFI
ER TERMINAL
amperes
MIC IN ETHERNE
T SPEAKER OUT
AC INPUT
AC POWER
BATTERY
NETWORK
STREAMING
iPA5060
Cat5e
Cat5e
See Note Below
MESSAGE INPUT
MAIN OUTPUT
PRE-AMP INPUT
SIREN
MIC
BALANCE LINE LEVEL
VOLUME
RESET
ETHERNET
-
+
DC 24V
NO
A B
RS485
SIREN
TRIG
MESSAGE
TRIG
RELAY
CONT
iEP 1200
ETHERNET EMERGENCY PAGING PANEL
amperes electronics
Another Quality Product From
MADE IN MALAYSIA
The dry contact at the MR1301 is used to trigger iEP1200, thus overriding the normal audio source for priority paging. It is then
connected to the Emergency Relay trigger at the Zone Selector, providing a dry contact for connecting 24V DC to override external
volume controllers.
Note:
By default, the mode of activation is momentary. For this configuration, set it to momentary, and the dry contact shall be closed for the
duration of the playback. This shall perform bypass of mixer audio output at iEP1200 until the message is stopped.
