IMAC2B009 V2
Uncontrolled Copy - Refer to Ampcontrol Website for Latest Version
Page 35 of 53
Ampcontrol Pty Ltd
– ABN 28 000 915 542
iMAC System User Manual
iMAC2B009 V4
– 10/18
A
P
P
R
OV
E
D
FOR
E
X
T
E
R
N
A
L
D
IS
TR
IB
U
T
ION
–
P
R
OP
E
R
T
Y
OF
A
M
P
C
ON
TR
OL
P
T
Y
LTD
–
N
O
T
T
O
B
E
R
E
P
R
OD
U
C
E
D
I
N
P
A
R
T
INSTALLATION
General Warnings
These instructions have been designed to assist users of the iMAC System with the installation of the
iMAC2 Controller.
Before the iMAC2 Controller can be installed, there are a number of points that need to be considered and
understood to prevent incorrect or unsafe operation of the iMAC2 Controller or the greater system into which
it is installed.
Along with relevant competence, and an understanding of the target application, the following points should
be considered:
8.1.1 Ensure that the information provided in this user manual is fully understood.
It is extremely important that the functionality and any limitations of the iMAC System are understood to
prevent incorrect installation or misuse. If in doubt as to the nature of the limitations or their implication,
consult a competent authority such as a site supervisor or Ampcontrol technical representative.
8.1.2 Ensure that the application into which the iMAC System is being installed has been properly
defined, designed and approved.
Any system intended to mitigate the risk of injury needs to be properly designed and implemented. Such a
system must be the result of structured risk analysis with the outcomes used to define the system
requirements. These requirements, in turn, will guide the choice of all components needed to implement a
safety system. Understanding the needs of the system will ensure proper selection of equipment.
8.1.3 Ensure that the iMAC System will properly perform the required functions within the system
design.
It is important to understand how iMAC components are intended to interact with other equipment within a
system. For safe and reliable use, it is crucial that neither the iMAC2 Controller nor its signalling be
compromised by incompatibilities with connected or nearby equipment. For example, avoid running HV
cables in close proximity to iMAC system cables.
8.1.4 Modifications of any form to the iMAC2 Controller and its associated modules are prohibited.
The iMAC2 Controller as supplied has been designed and manufactured to comply with the requirements of
the relevant electrical standards. If modifications of any form are made, the equipment may no longer be fit
for use. If any modifications or damage to the equipment is evident, do not use the equipment and contact
Ampcontrol for advice.