IntesisBox
®
Modbus Server – Mitsubishi Heavy Industries AC
User’s Manual r1.0 eng
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SL
URL
Email
tel
http://www.intesis.com
[email protected]
+34 938047134
16 / 26
Next, there is an explanation for each of the configuration parameters in each mode.
Modbus interface configuration parameters:
Figure 4.3
Modbus interface configuration
1.
Select the type of Modbus communication to use
(TCP, RTU or both).
If Modbus TCP is selected, then:
2.
IP IntesisBox:
Enter the IP address for IntesisBox
®
.
3.
Net Mask:
Enter the IP netmask for IntesisBox
®
.
4.
Gateway:
Enter the default gateway address for IntesisBox
®
; leave it blank if no
router is needed.
5.
Port:
Enter the TCP port to use (default for Modbus TCP is 502).
6.
Timeout Keep Alive:
Enter the time (expressed in seconds) that IntesisBox
®
will
wait, upon no TCP activity, to send a Keep
Alive packet. Enter 0 if you don’t want
IntesisBox
®
to send any Keep Alive packet (default 30 seconds).
If Modbus RTU is selected, then:
7.
Connection:
Select the physical media (EIA232 or EIA485)
1
.
8.
Baud rate:
Enter the baud rate of the serial communication.
9.
Parity:
Enter the byte parity of the serial communication.
10.
Slave:
Introduce the Slave number for the Modbus interface.
1
In the LinkboxMB this connection is labeled as RS232 and RS485 respectively.
2
3
4
5
6
7
8
9
1
10
AMP Air Conditioning
www.ampair.co.uk | [email protected]
