AMIMON Connex LR, Руководство пользователя

Страница: 25 / 56

Multicasting to Multiple Ground Units
A single Air Unit can transmit video downlink to up to four Ground Units. This is called multicasting . The
following procedure describes how to pair an additional Ground Unit with the same Air Unit.
NOTE
Note:
1. The Air and Ground Units provided in the same box are preconfigured to automati-
cally search for and connect to each other. Therefore, there is no need to perform
this procedure on the Air Unit / Ground Unit provided in the same box.
2. Controlling the Air Unit's camera gimbal is not recommended when the Air Unit is
registered to more than two Ground Units (even if only two of the registered
Ground Units are powered ON).
3. Register one Ground unit at a time to each Air unit.
Pairing Additional Ground Units with an Air Unit
To pair an additional Ground Unit with an Air Unit:
1. Set up the additional Ground Unit, as described in Setting Up the CONNEX Ground Unit [15] or in
the CONNEX Fusion/ CONNEX Mini Manual.
The Ground Unit must be placed between one and 10 meters from the Air Unit. Each Ground Unit
must be placed at least a few meters away from other Ground Units in order to enable optimal re-
ception.
The following message is then displayed on the monitor connected to the Ground Unit’s
HDMI
port :
"Ground Unit not registered to Air Unit."
2. Press and hold the Link button on the Ground Unit (for approximately five seconds) until its Net-
work LED starts blinking. The following message is displayed on the monitor connected to the
Ground Unit:
"Please activate registration on Air Unit."
3. Power on the Air Unit with which to pair this Ground Unit. This step assumes that the Air Unit has
already been set up, as described in CONNEX Fusion/CONNEX Mini manual.
Press the Air Unit’s
Link button for approximately five seconds until the Network LED starts blink-
ing. After the LED begins blinking, the following message is displayed on the monitor connected to
the Ground Unit.
"Air Unit detected. Please press the Link button."
4. Press and release the Link button on the Ground Unit (do not press and hold). The following mes-
sage is then displayed:
"Pairing in progress."
After a while, the monitor connected to the Ground Unit should display the video received from the
Air Unit.
NOTE
Note: If a black screen is displayed, check that the camera on the drone is operat-
ing.
Connex LR Manual
25