19
Amico Accessories Inc.
Standard Interface (Powered Manual Carts Only)
The Standard Interface has multiple purposes: it can control the lighting on the cart as well as indicate the battery
charge level, plug connection state and charging state.
The Charge Indicator LEDs show the approximate charge level of the Hummingbird Mobile Workstation's batteries. If
the indicator approaches 'E' signifying empty, connect the Hummingbird Mobile Workstation to a power outlet using
the supplied plug.
When plugged into AC power, the AC Power Indicator will illuminate. If the unit is charging the charge indicator will
also illuminate. When the unit has completed charging, the Charge symbol will turn off, however the plug indicator
will remain on until the unit is unplugged.
NOTE:
IT IS NOT RECOMMENDED TO LEAVE THE UNIT PLUGGED IN FOR LONG PERIODS OF TIME AFTER CHARGING
IS COMPLETED.
NOTE:
IT IS RECOMMENDED THAT THE BATTERIES ARE STORED IN FULL, OR CLOSE TO FULL STATE, FOR OPTIMUM
LONGEVITY OF THE BATTERIES.
The Auto Shutdown indicator is illuminated when the system has very low battery power. If this indicator is
illuminated, immediately save any open documents and plug the unit into an AC wall outlet.
The Recovery LED illuminates if the batteries have been over discharged. The system will enter a slow charge state
(when plugged into wall outlet). This process may take 24 hours or more.
The Recovery LED will flash if the system is overheating. If this occurs, shut down all devices connected to the
Hummingbird and allow the system to cool for 2 hours before resuming use.
WARNING:
IF RECOVERY LED FLASHES ON A SYSTEM USING AN SLA BATTERY (AND/OR ROTTEN EGG ODOR IS
DETECTED), IMMEDIATELY DISCONNECT POWER (IF CHARGING) AND VENTILATE/EVACUATE THE AREA. IT IS THE
MEDICAL FACILITY'S RESPONSIBILITY TO TRAIN ANY PERSONNEL USING THE HUMMINGBIRD TO ACT
ACCORDINGLY IN SUCH SITUATIONS. CONTACT AMICO FOR SERVICING. (NOTE: THIS ERROR IS UNCOMMON
AND IS UNLIKELY TO OCCUR).
NOTE:
THE POWER CORD IS EASILY DETACHABLE AND CAN BE DISCONNECTED FROM THE CART IF NECESSARY.
IF DETACHED, ENSURE THE CABLE IS FULLY PLUGGED IN BEFORE RESUMING USE.
The Lighting Indicator/Switch (capacitive touch) is used to turn the lights on the Hummingbird mobile workstation
on/off and will be illuminated when the lights are on.
To adjust the brightness of the Hummingbird lights, hold the Lighting Switch until the brightness begins to cycle.
Release the switch when desired brightness is achieved.
Section 6: Adjustments
Battery Level
E
F
1/2
1/4
3/4
Recovery
Light Indicator/Switch
Charge Indicator LEDs
AC Power Indicator
Charging Indicator
