www.amico.com
14
Mounting a Monitor: VESA 75/100 (LCD Carts Only)
WARNING:
ENSURE THAT THE VESA PLATE IS AT THE TOPMOST POSITION BEFORE MOUNTING OR REMOVING
DEVICES FROM THE FIT POST.
NOTE:
4 x M4 SCREWS ARE PROVIDED FOR MOUNTING THE MONITOR TO THE VESA HEAD. DIFFERENT SCREWS
MAY BE REQUIRED IF THE HOLE DEPTH IN THE MONITOR DOES NOT MATCH THE SCREW SIZE. STANDOFFS MAY BE
NEEDED DEPENDING ON THE MONITOR'S HOLE PATTERN.
NOTE:
ALLOW 90
°
ROTATION IN BOTH DIRECTIONS FOR EXCESS CABLING.
1. Determine the mounting configuration on the monitor – VESA 75 (75 mm x 75 mm M4 thread) or VESA 100 (100
mm x 100 mm M4 thread).
2.
VESA 100 Configuration:
Partially thread 2 M4 screws into top 2 holes in the back of the monitor. The monitor
can then be hung on the VESA plate through the two slots at the top. Insert 2 more screws through the VESA 100
mounting holes at the bottom and tighten all screws
(Figure 1)
.
3.
VESA 75 Configuration:
Rotate the VESA Plate so that the 2 slots for the VESA 75 configuration are located at the
top of the plate. Partially thread 2 M4 screws into top 2 holes in the back of the monitor. The monitor can then be
hung on the VESA plate through the two slots at the top. Insert 2 more screws through the VESA 75 mounting holes
at the bottom and tighten all screws.
4. When removing the monitor, ensure that the monitor is at the topmost position (applicable only when FIT Post
contains a gas spring for vertical adjustability). Remove the 2 bottom screws from the VESA plate, and loosen the
top 2 screws. Carefully lift the monitor off the VESA plate.
Figure 1: VESA Plate
M4 mounting holes
for VESA-100
Section 5: Device Installation
M4 mounting holes
for VESA-75
