Amico AH6000LN, Руководство пользователя

Страница: 24 / 35

3. Remove the screw plug on the cylinder head cover and refill 2cc engine oil, then
put the plug in place,
4. Turn the engine 2~3 seconds with the decompression lever set at the non-com-
pression position, and the starting key at the "START" position.( (Do not start the
engine.)
5. Pull the decompression lever up. Pull the recoil starter slowly. Stop when you feel
resistance.( at this position, both intake/exhaust valves are closed to prevent the
engine from the rust.)
6. Wipe off the oil and dirt from the engine and store in a dry place
19
10.TROUBLESHOOTING AND REMEDY
A
VR is damaged.
Remedy
The generat-
i n g s e t c a n
not generate
The diesel engine can not start
Refill the fuel oil T
urn it to ST
AR
T position
Remove the nozzle and repair it at test table. Set the leverto ST
AR
T position
The specified oil level should be between the upper level and lower level.
Clean the nozzle Start the engine according to the start pro- cedures included in this book. Charge it or replace it with a new one. T
urn the main switch to ON position
.
Replace the carbon brush. Adjust the socket. Adjust it according to the requirements. Replace the A
VR
Fault Cause Fuel oil is not suf
ficient
Fuel cock is not at ST
AR
T position
Fuel injection pump and nozzle do not delivery the fuel or delivery in- suf
ficient fuel.
The governor lever is not at ST
AR
T
position. Check the engine oil level. The nozzle has dirty
.
The speed and force to pull the re- coil starter are not enough, The battery has no electricity
.
Main switch not be turned on, The carbon brush already worn. The contact of the socket is not good. The rated speed can not attached.