amiad Omega 13.5K, Руководство по установке и эксплуатации

Страница: 34 / 93

OMEGA F ilt ers – Ins tal lati on & Oper atio n Manu al Pag e 4 of 4
Installation Instructions
Electrical installation
c. Electrical installation
1. All electrical works at the installation site must be done by a qualified and authorized electrician
only. Make sure that this electrician is fully aware of all the relevant safety instructions, is familiar
with the electrical design of the system and has in hand the relevant approved wiring diagrams.
2. Recommendation for the connection of the power supple cable to the motor:
o
Connect the power cable to the drive unit using a long enough cable to allow the drive units to
be removed and placed near the filter for maintenance, without having to disconnect them
from the cable.
o
The installation of this power cable is considered as a "high" voltage connection and its
connection should be performed according to the relevant local or national electrical codes for
such a connection.
3. Recommendation for the connection of Control instruments:
o
Prior to the connection it is recommended to review the data sheets of the relevant instruments
and review their connection diagrams
o
The connection of the control instruments to the control system must be performed according
to the accepted and approved wiring diagram.
d. Pneumatic installation
1. The pneumatic connection in the case of the OMEGA filters for this system refers only to the
Actuators of the flushing valves.
2. Prior to the connection of the air supply to the solenoids, it is recommended to review the data
sheets of the solenoid and verify the connection type for the air supply (dimension and threading)
3. Make sure that air supply to the filter is regulated and dried and featured with a pressure release
mechanism.
4. Connect the piping according to the local standards and requirements.