MAN-X5L-ENG-01
2
ⓒ
2016 All Material Handling
HOIST NAMEPLATE with basic warnings and information as required by ASME B30:
It is recommended to copy; Model, and Serial number into the
blocks on top of the cover of this manual. Make a copy of this
manual available to all operators. Note that the “Overload
Protection” label will only appear on units so equipped. Below,
the warnings are translated:
WARNING
To avoid serious injury or death
Read manual before operating
Do Not remove or obscure this label
Do Not operate if restricted in forming straight line between hooks
Do Not operate with lever extension or with other than
manual power
Do Not operate with a twisted, kinked, or damaged chain
Do Not lift people or loads over people
Do Not operate a damaged or malfunctioning hoist
Do Not lift more than WLL
1.0 OPERATION:
The operator must read and understand Warnings and operational
instructions in this manual and as displayed on the hoist.
Set up using free chain mode to pull chain in or out by hand
1. Under no load, move the selector to neutral “N” position.
2. Pull the hand wheel out then counterclockwise (CCW) to hold
position. (Do Not attempt to pull out or rotate when hoist is loaded)
3. Pull chain in or out by hand. (Too quick or fast and the brake
will set and the set up must be repeated.)
4. Attach hook to load.
Set the Brake and prepare to load
5. Quick pull on the tail chain to tighten the chain against the load
or turn the hand wheel clockwise (CW). The hand wheel will then
return to the “in-position” when the chain is snug against the
load. (Without load, hold the chain with bottom hook and turn the
hand wheel clockwise CW)
6. Turn the selector to the up “U” position.
Load the hoist to begin lift or pull.
7. Ratchet the lever in the clockwise (CW) direction to lift or pull.
Move selector to Down “D” and ratchet in the counterclockwise
(CCW) direction to lower the load.
8. Confirm proper operation by Lifting or pulling until the full load
is suspended. Stop and check if rigging and the hoist holds the
load without slipping. If confirmed then continue the lift or pull.
Detaching the Load
9. Secure the load.
10. Release tension on the chain by turning the selector to down
“D” and ratchet the lever in the counterclockwise (CCW)
direction until enough slack to detach the hook. Pull chain out
by hand to provide resistance to allow the lever to ratchet.
Instruction
Label
Hand
Wheel
Selector
Name
Plate
Tail
Chain
Stop
Overload
Protection
Clutch Label
(if equipped)
