Ametek Thermox WDG-VRM, Руководство пользователя

Страница: 77 / 104

Diagnostics
|
7-3
control Diagnostics
Diagnostics mode is turned on when changes are made on this menu so
that the system does not accidentally trigger an auto calibration while
troubleshooting.
1. Use the left and/or right navigation arrows to locate the Control Diag-
nostics menu and press the EntEr / mEnu key.
When you press the EntEr / mEnu key a message appears on the
Status Bar at the bottom of the screen “Diagnostic mode: OFF.” this
changes to Diagnostic mode: On if you make any changes. Press the
CAnCEL key to exit and turn off Diagnostics mode.
2. There are three screens that make up the Control Diagnostics menu:
Analog I/O, Relays, and Close Contact.
control Diagnostics: analog i/o screen
Figure 7-1a. Diagnostic Mode. set analog Value screen.
This screen displays the three Outputs available and the Set Values and Ac-
tual Values. You can use the navigation arrows to access the Set Value fields
and change these values.
making a change to any of these fields will turn on the Diagnostic mode.
Press the CAnCEL key if you want to exit Diagnostics mode.
3. Use the right navigation arrow to move to the Relays screen.