Ametek Drexelbrook Universal IV CM, Инструкция по установке и эксплуатации

Страница: 14 / 128

Universal IV™ CM Density Compensated Model
7
Section 2: Installation
2.1 Mounting the Unit
There are 2 electronic units for the Density Compensation Cut Monitor.
The DCM is a remote mounted unit. This module has connections for 24 VDC power,
a 4 – 20 mA signal loop, Modbus digital output and a relay (SPST).
The Cut Monitor Transmitter is either mounted integral to the probe or remote
mounted. This unit is connected to the probe and power is provided by the Density
Compensation Module. For remote mounting greater than 100 ft. consult factory.
Reference the Universal IV Cut Monitor manual for mounting of this module
Remote electronic units are designed for field mounting, but should be mounted in a
location as free as possible from vibration, corrosive atmospheres, and any possibility of
mechanical damage. For convenience at start-up, mount the instrument in a reasonably
accessible location. Ambient temperatures should be between -40°F and 167°F (-40°C
and 75°C)
Section 2
Density
Compensation
Module
(DCM)
Spool Probe
Cut Monitor
(CM)