Ametek Powervar ABCE1002-11R 58100-01R, Инструкция по эксплуатации

Страница: 21 / 66

21 A01-00071 Rev F www.powervar.com
Reference the below UPM fault code chart to identify the status of the UPM.
UPM Status Code Definition
IF Inverter fault
BE Back-Feed fault
HL Unit is off due to a high line
LL Unit is off due to a low line
DB Unit is off due to a low battery
FF Fan fault
SF Site wiring fault
NOTE:
• If the UPM is on continuously, it will perform an auto battery test every
six days.
• If you are utilizing MopUPS Pro software, you can configure the sys -
tem to automatically self-test periodically.
• The UPM is shipped with a charged battery, but some discharge
naturally occurs during storage and shipment. You may use the UPM
immediately, but you should realize that backup time may be less than
the stated rating until the UPM battery has had at least six hours to
charge.
• AMETEK Powervar recommends that you do not plug laser printers
into the UPM. Laser printers are known to draw large amounts of
current when the fuser/heater assembly is energized. Laser printers
can easily overload the UPM or create a low voltage condition that can
interfere with the operation of the Voltage Manager circuit.
Page 1
Rear Panel - Rack mount
4/10/17
Rev.1 PH
POWERVAR Inc.
ON
OFF
1 2 3 4