
26
A01-00071 Rev F
www.powervar.com
2.
Slide to the right then tip away from the
front of the unit slightly.
3.
Gently remove bezel in direction of arrow.
5.
Removing Front and Battery Retention Plate
* Battery connect on the front of the unit for the 4U units.
*
UPM 2U UPS (700VA, 1000VA, 1500VA)
The batteries for this unit can be changed while the unit is on. Unit's alarm will
beep while changing the battery. To replace the battery pack inside the UPS:
4.
Once the bezel is removed, unscrew the two screws on the battery retention plate located on the
center of the unit and remove the plate by sliding slightly to the right to disengage the hooks.
6.
Disconnect the battery from the UPS by grasping and pulling the battery connectors straight
out. Slide the battery out from the UPS.
7.
Slide new battery into the UPS and reconnect proper colors to connectors (red/red,
black/black). The battery connector is polarized and will only fit one way. Make sure it is
completely installed.
8.
Replace and secure the battery retention plate with the screws. Replace the front bezel by
reversing all three steps required previously for removal.
NOTE:
Do not replace the front bezel without first securing the battery retention plate.
UPM 4U UPS (
22
00VA, 3000VA)
Battery replacement procedure is the same as for the 2U units above. However there are two
sets of batteries, each located behind the front bezels on the 4U UPS.
NOTE:
Both sets of batteries must be replaced at the same time to ensure proper operation and
expected runtimes.
See “Instruction for Returning a Depleted Battery Pack” for instructions on returning
depleted battery(s) to AMETEK Powervar.
A01-00074 Rev. C
AMETEK-Powerver battery packs can be replaced
without turning off the power or disrupting the
protected equipment.
After replacing the batteries in the Security II, the
LED display should illuminate all five bars in the
battery icon. If any of the bars are flashing, the
batteries are in the process of charging.
If charging does not complete within 4 to 8 hrs,
contact AMETEK Powervar Technical Support.
Technical Support
AMETEK Powervar offers 24-hour technical support,
to contact AMETEK Powervar Technical Services call:
(847) 596-7000 |
Toll free:
(800) 369-7179
Europe:
+44 (0) 1793 553980
E-Mail:
Please check with AMETEK Powervar Technical
Services before attempting to repair or return any
product. If a unit needs repair or replacement,
AMETEK Powervar Technical Services will issue a
Return Material Authorization (RMA) number along
with instructions on how to return the product.
Instructions for Returning a
Depleted Battery Pack
AMETEK Powervar provides for pre-paid return of
depleted batteries with all replacement battery
purchases. Just follow these simple steps:
1.
Remove the new battery pack and install it in the
AMETEK Powervar unit as per the installation
instructions. Put the FEDEX label aside
2.
After the battery pack has been replaced, place
the depleted battery pack in the box the same way
the new battery was packaged and seal the box.
3.
Follow the return instructions on the back of the
FEDEX label and affix to the box
4.
To return to AMETEK Powervar for proper
recycling (at no cost to you), give the
box to any FEDEX pick-up driver or call
1-800-393-4585 for the nearest drop off location.
Security II Rackmount UPS
Battery Replacement Instructions
VISIT OUR WEBSITE AT:
www.powervar.com
1.
Pull bezel slightly at the left corner.
Содержание ABCE1002-11R 58100-01R
Страница 13: ...13 A01 00071 Rev F www powervar com...