AmeriWater MRO2X, Руководство по эксплуатации и техническому обслуживанию

Страница: 30 / 55

MRO2X
– 5X Manual
- 26 -
98-0058
Rev. R
SECTION 6, MRO CONTROLLER
6.1
FRONT PANEL CONTROLS AND INDICATORS
FIGURE 6.1
DISPLAY - Shows status of system.
ALARM LAMP - Flashes when fault causes an RO system shut down.
On steady when a Setpoint is exceeded that does not
cause an RO system shut down.
POWER KEY - Places controller in operating or standby mode.
LEFT ARROW KEY - Scrolls through Setpoints starting with first Setpoint.
RIGHT ARROW KEY - Scrolls through Setpoints starting with last Setpoint.
UP ARROW KEY - Increases value of Setpoint.
DOWN ARROW KEY - Decreases value of Setpoint
ENTER KEY - Confirms entry of new Setpoint value
ALARM SILENCE/RESET KEY - Push once for alarm silence and twice to reset system
after a shutdown has occurred.
ACCESSING DISINFECT MODE - Push and hold the left arrow key, and then push the
right arrow key.
NOTE: The J2 jumper must already be installed to make this an
active mode. Ref. Fig. 6.2.
DISINFECT - Push the ENTER key and hold until all of the solution is
drawn into the MRO.
DISPLAY