AMERICAN ULTRAVIOLET Lesco SUPERSPOT MK III, Техническое справочное руководство

Страница: 20 / 54

KMM1002P
18
5. Plug the leads into the matching colored sockets and replace the housing.
(NOTE:
Be certain the black bulb lead wire is
NOT
pinched between the housing and
retainer clips. Lead wire should be free of pressed contact from bulb to socket.
)
Re-attach the cover to the main unit. Next connect the power cord to the rear of the
MKIII and into the power outlet.
6. Insert the lightguide into the receptacle located in the upper center section of the front
control panel of the MKIII.
** WARNING **
Do not look into the emitting end of the lightguide. Use proper shielding
at all times. Safety glasses are provided with each system.
Avoid exposing skin to UV light. Shielded UV enclosures
and safety glasses are available for purchase from AUV/LESCO.
** CAUTION **
Check input voltage and set input power module switch before plug in.
** CAUTION **
Disconnect power from system or unplug system from wall or
VAC power source before connecting the footswitch adapter.
7. Turn on the power switch located on the back of the MKIII above the power cord
receptacle; the system takes two minutes to warm up. If for some reason the bulb
does not light (indicated in the bulb-on window), turn the power off then on again to
strike the bulb.