T O P
1.
Remove the four COVER SCREWS
(1)
and COVER
(2)
from ELECTRICAL BOX
(3)
.
Fig. 10.
2.
Install BATTERY
(4)
into holder on DC circuit board.
Press BATTERY
(4)
down (contacts facing downward) into
position until tabs lock BATTERY
(4)
into place.
3.
Attach the SAFETY CHAIN
(5)
from the FRONT
PANEL
(6)
to the MOUNTING POST
(7)
as shown.
Feed the Red and Black wires through the back opening
in the ELECTRICAL BOX
(3)
.
Fig. 11a.
4.
Install the SENSOR WIRE GROMMET
(11)
into the
COVER
(2)
as shown.
Remove the SPLIT PLUG
(11a)
from SENSOR WIRE GROMMET
(11)
. Insert SENSOR
WIRE CONNECTOR
(8)
through SENSOR WIRE
GROMMET
(11)
. Insert SENSOR WIRE
(9)
into SPLIT
PLUG
(11a)
. Push SPLIT PLUG
(11a)
into SENSOR
WIRE GROMMET
(11)
to seal.
Fig. 11b.
8.
Insert SENSOR WIRE CONNECTOR
(8)
into
CIRCUIT BOARD RECEPTOR
(10)
slot.
Fig. 11b.
9.
Replace COVER
(2)
. Tighten COVER SCREWS
(1)
firmly.
7
Fig. 11a
Fig. 11b
Fig. 12
1
2
3
4
6
11
2
11a
8
9
1
CONNECT FRONT PANEL TO
ELECTRICAL BOX (DC POWER
BATTERY); Fig. 11
8
Fig. 11
1.
Install the two TABS
(1)
on the back side of FRONT
PANEL
(2)
into the two SLOTS
(3)
located on the top
edge of the ELECTRICAL BOX
(4)
.
Fig. 12.
2.
Push on the bottom edge of the FRONT PANEL
(2)
until it snaps into place.
If FRONT PANEL
(2)
will not
snap into place, then loosen the MOUNTING SCREWS
(6)
on the ELECTRICAL BOX
(4)
slightly.
Fig. 12.
3.
To remove FRONT PANEL
(2)
insert WIRE KEY
(5)
(supplied) into the two holes located at the bottom of the
FRONT PANEL
(2)
. Push the WIRE KEY
(5)
up until it
releases the bottom clips. Pull the bottom edge away and
lift the FRONT PANEL
(2)
off.
Fig. 12.
INSTALL FRONT PANEL; Fig. 12
9
PUSH TO
SNAP PANEL
INTO PLACE
5
2
T O P
5
7
BLACK &
RED WIRES
T O P
1
2
3
4
6
T O P
3
10
M968550 REV. 1.5
