3
5
7
6
T O P
1.
Remove FRONT PANEL.
For removing front panel
see Step 9 for instructions.
2.
Remove the four COVER SCREWS
(1)
and COVER
(2)
from ELECTRICAL BOX
(3)
.
Fig. 16.
3.
Disconnect GREY SENSOR WIRE
(4)
from CIRCUIT
BOARD
(5)
.
4.
Remove CIRCUIT BOARD
(5)
from ELECTRICAL
BOX
(3)
.
Fig. 16a.
5.
With your thumbs, spread the two TABS
(6)
on
battery holder apart and remove the BATTERY
(7)
.
2.
Install NEW BATTERY
(7)
into holder on DC circuit
board. Press BATTERY
(7)
down (contacts facing
downward) into position until TABS
(6)
lock BATTERY
(7)
into place.
6.
Install CUIRCUIT BOARD
(5)
and connect GREY
SENSOR WIRE
(4).
7.
Install COVER
(2)
and SCREWS
(1)
.
8.
Replace and FRONT PANEL.
See Step 9 for
instructions on installing front panel.
10
HOW TO INSTALL NEW BATTERY;
Fig. 16
13
14
Fig. 16
Fig. 16a
Fig. 17
1
4
2
3
5
T O P
CLOCKWISE
CLOSES
CONTROL STOP
COUNTER-CLOCKWISE
OPENS CONTROL STOP
IMPORTANT:
To avoid overflowing, the SUPPLY STOP
(2) must never be opened to the point where the flow
from the valve exceeds the flow capacity of the
fixture. The fixture must be able to handle a
continuous flow in case of a flush valve failure.
Valve is designed to provide stated flush volume with
a 25 GPM flow rate.
1.
After installation is complete, peel off the PROTECTIVE
FILM
(1)
from the sensor. Standing to one side, block the
sensor with your hand for 10 seconds.
Remove your hand
and listen for audible “click” from within the valve.
2.
Turn on SUPPLY STOP
(2)
1/4 turn to 1/2 turn(CCW)
and test for leaks.
Note:
Unit may flush for
approximately 5 to 10 sec. when water is first turned
on. If flow persists, turn water off and repeat step #1
above.
3.
Actuate the FLUSH VALVE:
A) Cover sensor with hand for 10 seconds.
NOTE: Stand outside of sensor detection aera.
B) Remove hand from in front of the sensor; unit will
flush in approximately 3 seconds.
4.
Adjust SUPPLY STOP
(2)
after each flush until the
stated flush volume is achieved, no splashing occurs and
the fixture is properly cleansed.
ADJUST SUPPLY STOP; Fig. 17
1
2
M968550 REV. 1.5
