American Sanders B-2+DC, Руководство оператора

Страница: 10 / 46

10
Operating Instructions
EN
DANGER:
Failure to remove the electrical plug from the electrical
outlet before attempting any service or maintenance
could result in electrocution or severe injury. Always
unplug the machine before attempting any service.
Never leave machine unattended while plugged in.
To operate the machine follow this procedure:
1. Move the machine to the location of your work.
2. Connect the extension cord to the short power cord on the
machine. See figure 5.
3. Connect the other end of the extension cord to the power supply
outlet.
4. Put the variable speed switch in the "HI" position (1). See figure
6. After reaching full speed, put the switch in the "LO" position if
low speed is needed.
NOTE: The high speed operation is for fast wood removal. For finish cuts
and custom work, use the low speed operation.
5. Tilt the machine back so that the sandpaper disc does not touch
the floor See (1) in Figure 7. Hold both handles. See (2) in
Figure 7.
6. Put the On/Off switch in the "ON" position. See (3) in Figure 7.
7. Keep the machine moving as you lower the sandpaper disc to
the floor surface.
8. Do not press down on the machine. The weight of the machine
gives enough pressure for all types of sanding.
Figure 5
Figure 6
NOTE: Do not store or rest the machine on the sanding disc assembly.
It may cause the disc to become warped or cause it to be out of
balance.
Figure 7
2
1