MONITOR ARM
7
INSTALL DUAL MONITOR MOUNT
INSTALL DUAL MONITOR MOUNT
INSTALL SINGLE MONITOR MOUNT
INSTALL SINGLE MONITOR MOUNT
STEP 7
STEP 8
Ring Light & HD Webcam Mount
Attach Microphone & Light Controller
STEP 7a - Assemble MONITOR ARM onto the pole as shown and
secure by tightening arm support bolt with 6mm Allen Wrench Key.
STEP 7c - Place WEBCAM BRACKET on RING
LIGHT PLATE
STEP 8a - Place microphone in cradle and fasten
threaded knobs. Hand tighten only. (run USB-C cable
into mic and run cable along arm to USB-3.0 hub)
STEP 8b - Place rubber controller
holder and grip onto mic cradle
STEP 8c - (Run RING LIGHT & MIC USB cables
from base of stand to front of mic arm, use
rectangle clips to secure wire). Insert light
controller into rubber boot.
STEP 7b - Attach RING LIGHT/WEB CAM PLATE to
monitor arm. Fasten with thumb knob.
STEP 7d - Attach 6" RING LIGHT to base of RING LIGHT PLATE and thread
with 1/4"-20x0.40 thumbscrew. Attach HD WEBCAM to upper base of
WEBCAM BRACKET, fasten with 1/4"- 20 x 0.25 thumb screw (run Webcam
and light cable down back of stand to base, use round clips to secure).
GRIP
LIGHT
CONTROLLER
BOOT
1/4"-20 x 0.25"
THUMBSCREW
1/4"-20 x 0.40"
THUMBSCREW
HD FULL
WEBCAM
0
5
25
75
95
100
ALLCAST MULTI STAND OWNERS MANUAL ver2.0
Saturday, February 20, 2021 3:05:57 PM
