Page
7
of
15
AE-G12N & G22N
Operation Manual
773.376.0800 (P) • 773.376.2010 (F) • 3131 S. Canal St. Chicago, IL 60616
Revision 8/2015
4.
Make sure the Teflon washer is mounted on the spiral propeller/auger. See Figure 3
5. Make sure the spiral propeller/auger is facing the correct direction. Slide the spiral propeller/
auger into the feed chamber with the Teflon washer installed. See Figure 4
6. Rotate and push the spiral propeller/auger until it locks into the motor unit. Ensure the auger is
firmly secure and fully inserted into the internal hub. See Figure 5
7. Place the knife onto the auger with the flat side (cutting edges) facing out. See Figure 6
8. Place the grinder plate onto the auger pin and rotate it until the notch in the plate lines up with
the pin on the feeder chamber, make sure the plate locks in place. See Figure 7
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Assembly Instructions
