American Dynamics AD615, Руководство оператора

Страница: 12 / 80

Getting Started 1-3
Moving Around the Screen and Selecting Choices
All screens in the configuration utility use the same controls to move the highlight bar around
the screen and to make selections. For combination keystrokes, press and hold each button in
sequence, then release.
Refer to your controller operating instructions for the locations
of the buttons.
Note : Where no specific Focus button is listed, either Focus Near or Focus Far may be
used.
Function Control
Starts the configuration utility ( SensorNet or
RS-422 only )
Iris Open, Focus, then
Zoom Out
Starts the configuration utility ( Manchester
only )
Key switch to Prog , 66 , then
Set Shot
Saves changes and exits the utility from any
screen
1
Iris Close, then Focus
Moves highlight bar to the previous item on
the screen Tilt Up
Moves highlight bar to the next item on the
screen Tilt Down
Moves highlight bar to the next position
right Pan Right
Moves highlight bar to the next position left
Pan Left
Selects the highlighted item on the screen Focus Far
Increases the value of the selected field or
displays the next choice for the field.
During naming, moves the cursor to the right
of the current character in the name.
Zoom In
(Zoom Tele)
Decreases the value of the selected field, or
displays the previous choice for the field.
During naming, moves the cursor to the left
of the current character in the name.
Zoom Out
(Zoom Wide)
Exiting the Utility
When you finish working with the configuration utility, you can save your changes and exit
the utility by pressing and holding
Iris Close
, then pressing
Focus Near
or
Focus Far
.
2
1
This command is not supported with Manchester.
2
Not supported with Manchester.