7
Battery Replacement:
(4067F Stubby Handle)
1) Unscrew bottom cap of handle and remove battery insert.
2) Replace with appropriate size batteries. Insert 1 battery positive
end first and the other negative end first into battery insert, paying
attention to the polarity markings. Slide battery insert back into han-
dle following the direction of the “Insert This Way Only” arrows.
Screw bottom cap on and tighten. (Figure 3)
NOTE:
Alkaline batteries should be used with your handle for maxi-
mum performance and are recommended for replacement. Ordinary
carbon zinc batteries may also be used.
Lamp Replacement:
(Standard Models)
For correct illumination, alignment, and assurance of watertight seal during
immersion/autoclave, we recommend using only ADC #4500-1 and #4501-1 replace-
ment lamps for standard blades.
1) To remove lamp on standard blades, grip lamp collar and rotate lamp counterclock-
wise until free.
2) Replace the lamp with a new ADC lamp.
3) Verify that lamp is sufficiently tightened before use.
CAUTION
: Be sure lamp’s glass surface is clean and free from fingerprints after assem-
bly. If necessary, the glass may be cleaned with a soft cloth or cotton ball moistened in alcohol.
Lamp Replacement:
(Fiberoptic Models)
For correct illumination and alignment we recommend using only
ADC replacement lamp model #5111N-4 (Figure 4).
1) Prior to removal, allow lamp time to cool.
2) Unscrew the laryngoscope head from the barrel of the handle in a
counterclock-wise direction.
3) Pull lamp out of the laryngoscope head. The lamp is friction fit and does not need to
be twisted.
4) Insert replacement lamp by firmly pressing into head until it is completely seated.
5) Screw the laryngoscope head onto the barrel of the handle. Tighten by hand only.
Main
Handle
Battery
Insert
AA Batter
y
AA Batter
y
Insert This W
ay Only
Figure 3
Main
Handle
Battery
Insert
A
A
B
a
tt
e
ry
A
A
B
a
tte
ry
Figure 4
In
s
e
rt
T
h
is
W
a
y
O
n
ly