American Changer AC2006, Инструкция по установке, эксплуатации и обслуживанию

Страница: 18 / 33

16
Low The amount of coins in the coin hopper is below its
operational threshold. First ensure there are enough coins
in the coin hopper to completely covert the metal plates
located at the bottom of the hopper. Second use Scotch-
Brite to scrub the metal plates. This is effective on dull
plates. Repair or replace the hopper.
Timed Out The coin hopper did not complete a payout in its allotted
time frame. Check the hopper for any coin jams or
mechanical obstructions preventing coins from exiting.
Have the unit repaired or replaced.
Bill Validator Bill Validator Error Conditions
If the validator fails, the display will show a
Credit Card
Only message. The status of the validator can be seen in
the System Info menu.
Motor Validator stacker/transport motor has failed. Repair or
replace the bill validator.
Sensor Sensor failure. Check for dirty sensors. Repair or replace
the validator.
CheckSum Indicates error with the firmware file stored on validator
main board. Repair or replace the bill validator.
Jammed A bill or debris is jammed in the validator bill path. Check
bill path for a jammed bill or debris. Repair or replace the
bill validator.
Cashbox The cashbox is not installed on the bill validator. Ensure
the bill box is properly installed on the bill validator. Repair
or replace the bill validator.
No Comm. The Flex-2 Board is unable to communicate with the bill
validator. Ensure the validator harness is connected
securely. Repair or replace the bill validator.
Out of
Service The Flex-2 Board has tried to enable the validator several
times without success.
Credit Card Credit Card Processing Device Error Conditions
If the credit card processing device fails, the display will
show a
Cash Only message. The status of the credit card
processing device can be seen in the System Info menu.