American Changer AC2006, Инструкция по установке, эксплуатации и обслуживанию

Страница: 16 / 33

14
1. IMPORTANT! Turn OFF the Main Board power, and turn it ON again after a few seconds. Note: The
printer will not work until the power has been cycled!
2. Enter the Setup Mode and perform a Printer Test. Make sure the printer prints all of the lines of
text and cuts off the paper.
Method #2 – Manual Feed:
NOTE: This method can be performed with the board powered ON or OFF.
1.
If there is paper remaining on the previous roll, it must be removed before proceeding. Move the
“Paper Feed Lever” from the DOWN to the UP positio n (refer to Figure P2), and then pull out the
remaining paper from the rear of the printer and discard the roll.
2. With the “Paper Feed Lever” still in the UP position, slide a new roll of paper onto the “Roll Holder,”
oriented so the paper comes off on the side toward the printer (refer to Figure P3 for the correct
placement).
3.
Wrap the paper under the “Paper Guide,” and begin to feed it into the “Paper Slot.” You do not
need to fold or cut the paper in any way; it should be left square in the front. Continue to feed the
paper into the slot, through the print head, until it passes out through the front of the machine
(refer to Figure P4).
4.
Move the “Paper Feed Lever” back to the DOWN position. The printer is now ready to print.
5.
Enter the Setup Mode and perform a Printer Test. Make sure the printer prints all of the lines of text
and cuts off the paper.