OPTIONAL SHAMPOO SHELF INSTALLATION
TIME REQUIRED
1/2 - 1 HR
10
4. On the 2 tiles the Shampoo Shelf will be replacing, mark 1”
from the outside of the grout line, the cut-out area will be
10” x 22”. Cut out the hole for the Shelf. The smaller the
hole the better.
5. Dry-fit the Shampoo Shelf for alignment of grout lines.
6. Using 100% RTV Silicone in-place with a generous bead
around the back of the lip, wipe off excess silicone with
tissue.
1. The Shampoo Shelf was designed to match your tile size.
(2) 12” x 24” tiles, the cut-out hole size is 10 x 22”.
2. There is a 1” lip or frame around the Shampoo Shelf, this will
be the water sealed area for the Shampoo Shelf.
3. The best way to cut the hole is with a small 5” round
diamond blade, and with a jigsaw to cut the corners.
See detailed instructions enclosed with Shampoo Shelf
11
8
DOOR HANDLE, HINGE, PANEL, DOOR & HEADER INSTALLATION
A - Door Handle Installation
1. Set the glass door in a position to enable the assembly of the handle
(diagram 18)
2. Loosen the set screws so you can separate the handles.
3. Unscrew the long bolt from the handle. Keep all rubber pieces attached to the screw.
4. Remove the first set of flat, clear washers from the bolt.
5. Start with the top hole on the glass door. Place the long bolt through the hole in the door
(keeping the remaining rubber pieces on the bolt). On the other side of the glass place the flat
washers onto the threaded portion of the bolt.
6. Take one side of the handle and screw the long bolt into the end. Just start the bolt until a few
threads catch. Keep loose.
7. Put the second bolt through the lower hole. Place the flat washer onto the bolt. Screw the bolt
into the bottom handle.
8. Align the handle on the door and carefully tighten the long bolts. Do not over tighten.
9. Place the opposite handle over the long bolts and tighten the set screws to secure the handle.
clear washer
clear spacer
clear washer
set screw
shower
inside
shower
outside
diagram 18
DH
DH
B - Hinge Installation
1. Locate the top hinge and remove the side plate by loosening the two screws.
(diagram 19)
2.
Apply a generous amount of
silicone
onto the hinge and side plate.
3.
Position the hinge onto the glass door lining up the holes so that the screws are on the outside
of the shower door. This will ensure a better water tight seal.
4.
Attach the side plate with
silicone
applied to the glass and tighten the screws until the
hinge is secure. Wipe off the excess putty and allow to dry.
5.
Repeat these steps for the bottom hinge.
diagram 19
GH
GH
GH
