6
PAN & WALL THRESHOLD TRIM
TIME REQUIRED
1/2 - 1 HR
8
diagram 11
diagram 6
metal pan
door threshld
silicone
P
A - Pan Threshold
1. Locate the door threshold and the panel channel rails (
diagram 6) (diagram 7)
2. Dry fit
3
.
Remove and place 100% RTV silicone on bottom of rails and in bottom channels, re-install.
B - Wall Threshold Trim
1. Locate side thresholds & top trim. (diagram 8)
2. To help with the side threshold installation, use a level and draw a plumb line from the inside of
the pan threshold up to the top of the shower. Do this on both sides. This line will be where
the side rails and the wall tiles meet, this will give you a visual reference point when dry-fitting
your wall tiles.
3. Apply 100% RTV silicone, using a circle pattern, to the cement board along the plumb line,
approximately 4 inches wide, to the edge of the shower pan.
(diagram 10)
4. Place the first side threshold into position, making sure to align the side rail with the vertical
plumb line previously drawn on the cement board. Apply pressure to the side threshold to bond
it to the cement board. The side threshold will be flush with the inside of the shower pan thresh
old and have a small gap where the pan threshold slopes.
(diagram 11)
5. Place the remaining side thresholds into position, 3 to each side & Cap. Make sure to use a
level and the plumb line previously drawn on the cement board to align the side thresholds
vertically.
TD
TP
TD TP
onto the front of the metal pan .
P
(
diagram 8)
CP
CP
diagram 8
Side thresholds (6) & Caps (2)
diagram 9
panel channel rail
TP
metal pan
P
door rail
TD
panel channel rail
TP
diagram 10
cement
board
100% RTV
siliconecircles
TD
diagram 7
metal pan
silicone
P
Threshold Panel
TP
Install TD, TP with
slight s
lope so water will drain into the pan
