©
American Audio
®
- www.americanaudio.us - 10MXR Instruction Manual Page 13
10MXR
CONTROLS AND FUNCTIONS cont.
main power is shut off before change the position of the Line Level Selector Switch.
17. CHANNEL 2: INPUTS - The type of input must directly reflect the selected mode of the CHAN-
NEL LINE LEVEL SELECTOR SWITCH (16). CD players, Tape Decks and other line level instruments
may be connected to these jacks. The red colored RCA jack represents the right channel input and
the white represents the left channel input. Input volume will be controlled by channel three fader.
The channel SOURCE SELECTOR SWITCH (3) must be in the “Analog” position, to monitor any
source connected to these jacks. Turntables equipped with MM pickup cartridge (All DJ turntable
use MM pick-up cartridges) may be connected to these jacks as long as the CHANNEL LINE LEVEL
SELECTOR SWITCH (16) is in the “PHONO” position. When CD players, Tape Decks and other line
level instruments are connected to these jacks the CHANNEL LINE LEVEL SELECTOR SWITCH (16)
is in the “LINE” position. Never connect line level instruments (CD players, tape decks, etc.) to these
jacks when the CHANNEL LINE LEVEL SELECTOR SWITCH (16) is in the “PHONO” position, THIS
MAY SERIOUSLY DAMAGE YOUR MIXER! The red colored RCA jack represents the right channel
input and the white represents the left channel input. The channel SOURCE SELECTOR SWITCH (3)
must be in the “Analog” position, to monitor any source connected to these jacks.
18. RCA MASTER OUTPUTS - The Master Output includes a pair XLR BALANCED JACKS (20)
as well as a pair of RCA Unbalanced Jacks. The RCA jacks send a low current unbalanced output
signal. These jacks should only be used for shorter cable runs to signal processors or looping to
another mixer. For cable runs greater than 15 feet use the XLR BALANCED JACKS (20).
19. BOOTH BALANCED XLR OUTPUT JACKS - The Booth Output 3-pin XLR jacks send a high
current balanced output signal. These jacks should be used when you will be driving an amp or
other audio equipment with a balanced input, or whenever you will be running a signal line greater
than 15 feet. Always, use these jacks whenever possible.
20. BALANCED XLR MASTER OUTPUT JACKS - The Master Output includes a pair of XLR
Balanced jacks as well as a pair of RCA UNBALANCED JACKS (18). The 3-pin XLR jacks send a
high current balanced output signal. These jacks should be used when you will be driving an amp or
other audio equipment with a balanced input, or whenever you will be running a signal line greater
than 15 feet. Always, use these jacks whenever possible.
22. AC CONNECTION -
This connector is used to supply main power to the unit via the included
detachable power cord. The power connection uses an I.E.C. type connector, use only the supplied,
polarized AC power cord. Use only a power cord that matches this type of connection. Be sure to
only connect this unit to a power outlet that matches the printed power label on the unit. Never use
a power cord when the ground prong has been removed or broken off. The ground prong is used to
reduce the risk of electrical shock in case of an electrical short. This cord is designed to fit in one
direction only. Do not attempt to force a cord if it does not fit, be sure the cord is being inserted
properly.
23. MAIN POWER SWITCH - This is the main power ON/OFF button. Before main power is applied,
be sure you have made all connections to the mixer. Also be sure your amplifier(s) is(are) tuned off.
Remember to avoid damaging pops to the speakers, the mixer is turned on first and turned off last.
