©
American Audio
®
- www.americanaudio.us - 10MXR Instruction Manual Page 10
assigned to its particular channel. However, master volume is controlled by the MASTER VOLUME
CONTROL (5).
3. SOURCE SELECTOR SWITCH - These switches are used to select the input source assigned to
each channel. Each channel may only be assigned one input source at a time. This switch must be in
the “ANALOG” position for turntable or line operation.
4. BROWSER CONTROLS AND FILTERS (MIDI) -
LOAD A (MIDI - This button will load the selected song to the Left deck. Use the SHIFT (9)
BUTTON to access the buttons secondary command Load selected song to secondary Left
deck.
LOAD B (MIDI) - This button will load the selected song to the Right deck. Use the SHIFT
BUTTON (9) to access the buttons secondary command Load selected song to secondary
Right deck.
ENCODER & PUSH ACTION (MIDI) - Turn the encoder to increase or decrease the selected
action. Pushing down on the encoder activates an action. See the navigation (Up, Down, FWD,
Back) buttons for more info.
UP (MIDI) - This control will set focus on the Left deck FX unit. The Encoder will set the amount
for Parameter 1 on the Left FX unit.
FWD (MIDI) - This control will set focus on the Song browser. The ENCODER will browse up/
down the song list.
DOWN (MIDI) - This control will set focus on the Right deck FX unit. The Encoder will set the
amount for Parameter 1 on the Right FX unit.
BACK (MIDI) - This control will set focus on the Folder browser. The ENCODER will scroll up
and down the Folder browser, pressing the ENCODER down will open or close Folders/Devices.
5. MASTER VOLUME CONTROL - This knob is used to control the master output level (main volume).
To avoid distorted output try to maintain an average output signal level no greater than +4 dB. To
avoid speaker damage that may be caused by excessive volume, be sure this knob is always set to
zero (completely down) before turning the unit on.
6. BOOTH LEVEL - This knob is used to adjusts the booth volume output level. Turn the knob in a
clockwise direction to increase the monitor volume.
7. CUE LEVEL VOLUME CONTROL - This knob is used to adjusts the headphone volume output
level. Turn the knob in a clockwise direction to increase the headphone volume.
8. CUE MIXING CONTROL - This functions allows you to monitor the Cue level as well as the
Program (main output) level in your headphones. A channels Cue Level may only be monitored if the
channels CUE (12) function is selected. To select a channels cue function press the CUE BUTTON
(12) that is directly associated with the specific channel you wish to monitor. You may use the mixing
function to blend both the Cue level and the Program level together. You can vary the output level to
either hear more or less of either of the two levels. Turning the Cue Mixing knob to the CUE position
(left) will allow you to hear more of the Cue level. Turning the knob to the PGM position (right) will
allow you to hear more of the Program level (main output). You may also use the Cue Mixing Control
to hear either the Cue level or the Program level exclusively. If the knob is in the full CUE position you
will only hear the cue level, if the knob is in the full PGM position you will only hear the main output.
This function is especially useful when mixing without an monitor.
9. SHIFT (MIDI) - The button has 2 functions a soft and a hard shift. A soft shift is performed by tog-
10MXR
CONTROLS AND FUNCTIONS cont.
