gling the shift button, this will be indicated by a blinking shift LED. A hard shift is performed by holding
down the shift button and combining it with another button.
NOTE: When performing a hard shift, it’s recommended you release the secondary button
before releasing the Shift button, this is to prevent MIDI latches unless the MIDI function is a
temporary function.
10. MASTER VOLUME LEVEL INDICATORS - The dual MASTER LEVEL LED indicators are used
to detail the master fader output level. The meters will detail the output level of both the left and right
channels.
11. FEATHER FADER PLUS CROSSFADER - This fader is used to blend the output signals of chan-
nels one and two together. When the fader is in the full left position (channel 1), the output signal of
channel one will be controlled by the master volume level. The same fundamentals will apply for chan-
nel two. Sliding the fader from one position to another will vary the output signals of channels one
and two respectively. When the crossfader is set in the center position, the output signals of both the
channels one and channels two will be even.
12. CUE, SYNC, PITCH BEND, & PLAY/PAUSE -
CUE 1 & 2 -
These buttons will set or trigger hot cue 1 or 2
.
DELETING HOT CUE POINTS -
If a hot cue point is set, it is indicated by a lit Cue button LED. If
you wish to delete a hot cue point, press the Shift button. The shift button LED will flash along with
the Cue LEDs. Press the Cue button that contains the hot cue you wish to delete. After,
press the Shift button again to disable the soft shift.
SAMPLER
(MIDI)
-
Virtual DJ has a built in Sampler. To use the sampler you must activate the
Sampler control. Pressing the Shift button and Up button will give you access to samples 1-4.
The samples can be triggered by pressing Cue 1 and Cue 2 on the right side of the mixer. The left
side being samples 1 & 2 and the right side being samples 3 & 4.
To trigger samples 5-8, you must activate the secondary sample bank. The secondary sample
bank can be accessed by pressing the Shift button and the Down button. The samples can be
triggered by pressing Cue 1 and Cue 2 on the right side of the mixer. The left side being samples
5 & 6 and the right side being samples 7 & 8.
PITCH BEND -
To perform temporary pitch bends in Virtual DJ, hold the Shift button and Cue 1 to
slow the track. To speed up the track hold the Shift button and press the Sync button. To reset
the pitch, hold the Shift button and press Cue 2.
SYNC -
Will sync the selected deck to the opposite deck or master deck/tempo.
CUE -
When the deck is playing, pressing this button will return to the 1st cue point. If the deck is
paused, pressing Cue will set a new cue point.
©
American Audio
®
- www.americanaudio.us - 10MXR Instruction Manual Page 11
10MXR
CONTROLS AND FUNCTIONS cont.
