©
American Audio
®
- www.AmericanAudio.us - Encore 2000 Instruction Manual Page 27
MIDI TABLE
CUE LEVEL
VR
32
71
Mix CH
CUEMIX
VR
33
72
Mix CH
CROSSFADER
VR
34
73
Mix CH
RELAY
SW/LED
14/14
53/--
Mix CH
--
--
--
--
CC-ABSOLUTE (VR)
Control Change messages are sent with status 0xBn, where n is the channel, for the specified CC
controller. Thus the controller MIDI ID is indicated with the channel along with the CC number. The
value from 0x00 to 0x7F, directly related to the location of the controller.
CC-RELATIVE (ENC)
Control Change messages are status 0xBn, where n is the channel, for the specified CC controller.
Thus the controller MIDI ID is indicated with the channel along with the CC number. The value from
0x40 to indicate the change in the controller. This is an offset to 0x40 “one’s complement” notation.
A message with data 0x43 indicates a
positive
change of 3.
A messages with data 0x31 indicates a
negative
change of 15.
SWITCH ON/OFF (SW,CENTER,CW,CCW)
These messages are used for switches.
Control Change messages are sent with status 0x9n, SWITCH On and Off value are 0x7F and 0x00,
where n is the channel.
LED ON/OFF (LED)
These messages are used for LED.
Control Change messages are sent with status 0x9n, LED On and Off value are 0x7F and 0x00,
where n is the channel.
PITCH BEND
Pitch Bend messages are status 0xEn, where n is the channel, for the specified controller.
Thus the controller ID is indicated only by the channel.
For accurate changes, the 14 bit data in a pitch bend message is reserved for absolute controllers
which require more than 7 bits of data.
LEVEL LED (LEVEL)
These messages are used for LEVEL.
Control Change messages are sent with status 0x9n, LED Off value is 0x00 and On value is related
to LED amount, 0x01 with one LED, 0x02 with two LED…., where n is the channel.
