GENERAL FUNCTIONS AND CONTROLS (Cont.) FRONT & REAR PANEL
©
American Audio
®
- www.AmericanAudio.us - Encore 2000 Instruction Manual Page 14
Figure 6
Figure 5
C. FRONT PANEL (FIGURE 5)
34. TRANSPORT TRAY 1 -
This tray is used to load and unload a compact disc. The tray is opened
and closed by pressing the Deck 1 OPEN/CLOSE BUTTON (1). Never attempt to force the transport
tray open or closed when the power is turned off. If the CD tray is left open for more than a minute it
will close automatically.
35. HEADPHONE JACK -
This jack is used to connect your headphones to the mixer allowing you to
monitor the cue source. Use headphones only rated at 8 ohms to 32 ohms. Most DJ headphones are
rated at 16 ohm, these are highly recommended. Always be sure the CUE LEVEL VOLUME (31) is set
to minimum before you put the headphones on.
36. TRANSPORT TRAY 2 -
This tray is used to load and unload a compact disc. The tray is opened
and closed by pressing the Deck 2 OPEN/CLOSE BUTTON (1). Never attempt to force the transport
tray open or closed when the power is turned off. If the CD tray is left open for more than a minute it
will close automatically.
D. REAR PANEL (FIGURE 6)
37. MICROPHONE -
This combo jack will accept a standard 1/4 plug or XLR 3-pin balanced male
plug. The volume output level for this microphone will be controlled by its own respective MIC KNOB
(29). Note: We recommend that you use a 500-600ohm microphone for the best sound quality.
38. LINE 1 INPUT JACKS -
TURNTABLES THAT HAVE A LINE LEVEL OUTPUT OR A PHONO PRE
AMP CAN BE CONNECTED TO THE LINE INPUT, OTHERWISE DO NOT CONNECT TURNTABLES
36
34
35
46
45
41 39
38
37
42
44
40
43
