OVERLAY DESIGN AND LAYOUT:
Graphic overlays (picture cards) can be changed easily by simply sliding the overlay through the side slot of the
housing grid. There are several methods you can use to make overlays for the Tech/Plus 32. Options include:
1.
Drawing or printing corresponding icons or words on a sheet of 6” x 13 ¼” paper. Section each icon
so that it appears in each of the 32 message switch cutouts.
2.
Developing your custom overlay using the Overlay Designer Pro or Tech Overlay Designer Software.
Tech Overlay designer is included on the resource CD as well as the instructions and on our website @
www.amdi.net.
3.
Developing your custom overlay using the Mayer-Johnson Boardmaker software. Blank templates are
available on the resource CD included and on our website @ www.amdi.net.
CLEANING THE TECH/PLUS 32
Note: DO NOT SUBMURGE THE TECH/PLUS 32 IN WATER OR ALLOW WATER TO ENTER THE
EXTERNAL SPEAKER, RECORD JACK OR SPEAKER HOLES... THE TECH/PLUS 32 IS WATER
RESISTANT – NOT WATER PROOF.
1.
Turn the Tech/Plus 32 off.
2.
Remove the overlay from the grid.
3.
With a wet wash cloth and mild soap wipe the soiled areas clean.
4.
To rinse, use a wet sponge (cold water) and wipe the away the soapy area.
5.
The grid can easily be removed for cleaning by unscrewing the 6 Phillips head screws on the back of
the Tech/Plus 32.
Care and Maintenance
The Tech/Plus 32 is designed to automatically power down after a message is played. However, the power down
mode is still an active mode and will drain some power from the battery, affecting battery life. Therefore, if the
Tech/Plus 32 is not going to be used for a long period of time (2 to 3 hours) it is recommended that the unit be
turned off.
If the Tech/Plus 32 should fail to operate, or operates incorrectly, follow these steps:
1.
Check that the batteries are fully charged or are somewhat new.
2.
Check that the Tech/Plus 32 is ON and a Message has been recorded at that level.
3.
Make sure that there are no obstacles blocking the message membrane square.
4.
Turn the Tech/plus 32 OFF for 15 Seconds, then back ON and retry playback.
5.
For further assistance, feel free to contact our technical support team at 1-888-353-AMDI (2634).
95
S
HERWOOD
A
VE
.,
F
ARMINGDALE
,
NY
11735
P
HONE
:
(631)
531-8888
F
AX
:
(631)
531-8811
1-888-353-AMDI
HTTP
://
WWW
.
AMDI
.
NET
