www.amcelettronica.com
SRL400/R V1.0 EN
green LED
DESCRIPTION OF THE ELECTRONIC BOARD OF THE TRANSMITTER
Two-colored LED
Learn key
The CSR400 transmitter has been designed to be used with radio-controlled R 400 series control units; as such, it does not require
to be programmed. Connect the FLAT cable of the transmitter board to the multi-polar socket in the control unit and follow the
programming steps described in the next chapters.
TWO-COLORED EXTERNAL LED:
GREEN COMBINATION = OPERATION OK
ORANGE COMBINATION = FAILURE
RED COMBINATION = FAULT
Two-colored LED - green combination:
-
Brief green flash every 4 seconds:
in standby operating mode
-
Steady on green:
system enabled
-
Slowly
flashing green:
system alarm
Two-colored LED - orange combination:
-
flashes orange every 4’’:
battet not charged
-
Slow orange flash:
battery charginb (low battery)
-
Steady on orange:
battery almost fully recharged
Two-colored LED - red combination:
-
Slow red flash:
very low battery (no power)
-
Fast red flash:
battery dead, replace
-
Steady on red:
buzzer has lost supervision.
GREEN LED inside the transmitter (RADIO PART SYSTEM AND CHECK):
-
Steady on
: transmitter not associated (not programmed for a buzzer)
-
Steady on for 1 second:
control transmitted to buzzer. (ALL OK)
-
Fast flah for 1 second:
status signal reception from buzzer (ALL OK)
-
Slowly flashing:
during self-learning phase (see below)
LOGIC OF THE LED ON THE TRANSMITTER
threaded antenna
Connector
fastening holes
