May 2020, Rev 4
Page
3
of
6
RESETTING OF DIGITAL DISPLAY TOTALIZER (type 8150)
(i)
Press UP key to scroll to "total 1" display.
(ii)
Press and hold the RIGHT arrow key until the display shows "rst tot1".
The totalizer will flash for 8 seconds and then it will automatically reset to 00000000.
•
Press the ENTER key while the display is flashing to reset immediately.
•
While the total value is flashing, you can cancel the reset by pressing UP and DOWN
keys together.
•
Totalizer #1 will be displayed for 5 minutes after the reset, then the standard totalizer
selection will return.
•
Press the UP or DOWN key to scroll back to the standard display immediately.
1
2
2 s
8 s
5 m
10.
NO FLOW AND ELAPSED TIME DISPLAY
If the flow stops, the Flow Rate displays the number of hours since flow was last detected. This
display will alternate with the normal Totalized Value and standard “no FLo” display every five
seconds. Any movement of the rotor in the pipe will reset the ELAPSED TIME display.
Illustrated: No flow for 3 hours
*************************************************************
If it is found, that after using the flow tester, that LPS or
a 0/1600 kPa gauge is required, the flow tester can easily
be converted when the unit is next sent to Ambit for
calibration/service.
*************************************************************
