16
www.ambient.de
ACN MENU
The ACN menu accesses the
A
mbient
C
lockit
N
etwork
configuration.
To enable ACN, select the MODE
In the release version of the ACN-TL, three different
network communication modes are available:
JAM,C-JAM, TX / RX
OFF: no wireless functions enabled.
ACN > JAM
The JAM mode allows to send a sync command to
other ACN-TL or ACL 204 devices or receive sync
command from them. This serves to remotely sync all
units on the set. First, the menu asks to select the
wireless channel.
The CHNL setting allows you to select between 16
network channels within the 2.4 GHz range.
The channel can be changed later.
After setting this, selection of internal or external
antenna is possible and powering the low noise
amplifier LNA for the receiver on or off. The LNA draws
power, so it is recommended only should the reception
of data be insufficient without. Default setting is
internal antenna, for activating the external antenna a
PIN code is required.
If the external antenna is activated, the antenna
symbol on the bottom right of the display is shown,
LNA is shown as well
PWR lets you increase the output power of the
transmitter. Default is 8 dBm, up to 18 dBm is possible.
Again, the PIN is required.
