Adjustments
68
Cenius 4002-2T BAG0100.2 04.13
8.2
Working depth of the levelling unit
The working depth of the levelling unit can be
adapted to the working depth of the tines at the
cranks.
1. Remove the linch pin (Fig. 43/1).
2. Adjust the working depth at the crank.
3. Secure the adjustment using the linch pin.
Turn the crank to the right
Reduce work-
ing depth.
Turn the crank to the left
Increase work-
ing depth
Fig. 43
Set the depth at all the adjustment units in the same way.
A scale is provided for orientation on the adjustment units (Fig.
43/2).
8.3
Adjusting the stripper
The strippers are set at the factory. To adjust the
setting to the working conditions:
1. Loosen the bolts.
2. Adjust the stripper in the slot.
3. Tighten the bolts again.
Wedge ring rollers
Do not adjust the distance between stripper and
spacer ring to less than 10 mm to avoid exces-
sive wear.
Tooth packer roller:
Adjust the distance between the scraper and
roller shell to 1 mm.
Rotate the roller to check whether the
distance of 1 mm is maintained at all
points. The carbide-coated scrapers
must not touch the roller shell.
Fig. 44
