Amazone AMATRON 3, Руководство по эксплуатации

Страница: 52 / 136

1.1 Editing the tractor geometry data
The implement geometry data is required for the GPS
switch to function properly. The part-width section con-
trol, track guidance and variable rate control depend on
the correct geometry.
The geometry data must be entered in the following
cases:
The tractor does not send any geometry data.
The geometry data sent by the tractor should not be
used.
The GPS receiver was installed on the tractor retro-
actively.
1. "Tractor data" > "Geometry data" .
2.
If the receiver is installed to the right of the centre
of the axle,
enter a positive value for the distance between the
GPS receiver and the centre of the axle under
"A"
or
If the receiver is installed to the left of the centre of
the axle,
enter a negative value for the distance between the
GPS receiver and the centre of the axle under
"A"
3.
If the receiver is installed in front of the centre of
the axle,
enter a positive value for the distance between the
GPS receiver and the centre of the axle under
"B"
or
If the receiver is installed behind the centre of the
axle,
enter a negative value for the distance between the
GPS receiver and the centre of the axle under
"B"
007574
I | Configuring tractors | Editing the tractor data
MG5560-EN-II
| B.1 | 2016.07 50