X212AFD
July 2021
15
Amate Audio
4 CONTROL AND CONNECTION PANEL
The X212AFD control panel contains the following elements:
Fig.9.
X212AFD control and connection panel
A)
TOUCHSCREEN:
Displays information about the System status: current preset,
network IP, amplifier temperature and signal input level. Allows the user to configure
the system without the need of an external computer: IP address setting, Preset
selection, Delay, Gain, Limiter, ECO mode on/off, Signal LEDs on/off, etc.
NOTE: The default PIN to access the setup menu is “1234”
B) STATUS LEDS
: Report a special event happening in the system:
•
Protect:
(Red) A fault condition is being reported by the amplifier. If this LED is
constantly lit even after resetting the device, please contact the technical service.
•
Standby:
(Orange) This led is lit when the equipment is set in Low Power
consumption mode. This can be done via the touchscreen (ECOMode ON) or
via PC. When ECOMode is in AUTO, the system will go into Standby after 5
minutes without signal at the input. When signal is present again, the system will
go automatically into normal mode.
•
Mute:
(Red) The system is muted (amplifiers are disabled). The system can be
muted from the PC remote control or from the touchscreen.
A
B
C
D
E
F
G
